Peugeot 1007 (2007-2010) Fuse Diagram

Advertisements

Fuse box diagram (fuse layout), location, and assignment of fuses Peugeot 1007 (2007, 2008, 2009, 2010).

Peugeot 1007 (2007-2010)

Checking and Replacing Fuses

Your vehicle’s electrical system is protected from overloading by fuses. If any lights, accessories, or controls in the vehicle do not work, inspect the appropriate circuit protector. If a fuse has blown, the inside element will be melted.

Before changing a fuse, it is necessary to:

  • Immobilise the vehicle and switch off the ignition,
  • Switch off all electrical consumers,
  • Identify the failed fuse using the fuse allocation tables and diagrams in the following pages,
  • Identify and correct the cause of the problem.

When replacing a fuse, you must always:

  • Use the special tweezer to extract the fuse from its holder and check the condition of its element,
  • Replace a failed fuse by one of the same rating (same colour); the use of a different rating fuse could cause a fault (risk of fire).

If the same fuse blows again, avoid using that system and have the vehicle’s electrical system checked by PEUGEOT dealer or a qualified workshop as soon as possible.

Notice

  • Never use a fuse of a higher or lower amperage rating than that specified. This could damage the electrical system or cause a fire.
  • Never replace a broken fuse with anything other than a new fuse (such as wire, foil, etc). Use always an intact fuse of the same color.
  • Your vehicle’s electrical system is designed to operate with standard or optional equipment. Before installing other electrical equipment or accessories on your vehicle, contact a PEUGEOT dealer or a qualified workshop.

The fuse boxes are located under the fascia on the left-hand side and in the engine compartment next to the battery.


Passenger Compartment Fuse Box

Left-hand drive:

Passenger Compartment Fuse Box Location (LHD)

  • Turn the screw a quarter of a turn, then tilt the cover to open it.
  • Turn the lever a quarter of a turn, then push and tilt the box to gain access to the fuses.

Right-hand drive:

Passenger Compartment Fuse Box Location (RHD)

  • Open the glove box, then tilt the cover to open it.
  • Turn the lever a quarter of a turn, then push and tilt the box to gain access to the fuses.
Passenger Compartment Fuse Box Diagram

AFunctions
FH1-Not used
FH240Trailer Fuse Box
FH3-Not used
FH420Audio amplifier
FH55"Sesame" doors control unit
115Rear wiper
35Air bags and pre-tensioners control unit
410Diagnostic socket - Clutch switch - Steering wheel angle sensor - Particle emission filter pump
530Electric windows - Sunroof
6-Not used
75Courtesy light - Glove box light
820Tyre under-infl ation detection control unit - Folding of the electric mirrors - Alarm siren - Multifunction display - Alarm control unit - Audio equipment - Audio/telephone
930Audio equipment - Lighter/12 V socket (100 W max.)
1015Steering wheel controls
1115Diagnostic socket - Low current ignition switch - Motorised strikers
1215Air bags and pre-tensioners control unit - Rain/brightness sensor
135ABS relay - Speed sensor - Engine Fuse Box - "2 Tronic" gear lever - Brake switch
1415Parking assistance control unit - "Sesame" doors control unit and switches - Instrument panel - Seat belt warning lights bar - Air conditioning control panel - Headlamp adjustment - Hands-free kit
1530Locking - Deadlocking - Unlocking
1740Rear screen and exterior mirrors demisting
SH-PARC shunt

Advertisements


Engine Compartment Fuse Box

Unclip the cover to gain access to the fuses.

Engine Compartment Fuse Box Location

Engine Compartment Fuse Box Diagram

 A Functions
MF150Fan assembly
MF230ABS/ESP control unit
MF330ABS/ESP control unit
MF460Built-in Systems Interface supply
MF560Built-in Systems Interface supply
MF630"2 Tronic" gearbox control unit
MF780Passenger compartment fuse box - "Sesame" doors control unit
MF880Electric power steering
120Engine control unit and fan assembly control supply - Injection control unit (Diesel) - Injection pump (Diesel) - Air heating solenoid valves (Diesel) - Air fl ow sensor (Diesel)
215Horn
310Front and rear wash-wipe pump
420Headlamp wash pump
515Fuel pump (petrol)
610Power steering control unit - Water in diesel sensor - Vehicle speed sensor
710Switching and protection unit (Diesel) - Engine coolant level detector (Diesel)
825Starter
910ABS/ESP control unit - ABS cut-off relay - Brake switch
1030Engine control unit actuators (petrol: ignition coils, oxygen sensors, injectors,purge canister and variable timing solenoid valves, controlled thermostat) (Diesel: injection control unit, air flow sensor, injection pump, diesel high pressure regulator, EGR and Turbo pressure regulation solenoid valves) - Blow-by heaters - Diesel heater
1140Air blowers
1230Windscreen wipers (low/high speed)
1340(Ignition positive) Built-In Systems Interface
14-Not used
1510Right main beam headlamp
1610Left main beam headlamp
1715Left dipped headlamp
1815Right dipped headlamp

* The maxi fuses provide additional protection for the electrical systems. All work must be carried out by a PEUGEOT dealer.


 

Advertisements