Honda Fit (2006-2008) Fuse Diagram

Fuse box diagram (fuse layout), location, and assignment of fuses and relays Honda Fit (Base, Sport, DX & LX) (GD; 2006, 2007, 2008).

Checking and Replacing Fuses

If something electrical in your vehicle stops working, check for a blown fuse first. Determine from the chart on pages and or the diagram on the fuse box lid, which fuse or fuses control that device. Check those fuses first, but check all the fuses before deciding that a blown fuse is the cause. Replace any blown fuses and check if the device works.

1. Turn the ignition switch to LOCK (0). Turn headlights and all accessories off.
2. Remove the cover from the fuse box.
3. Check each of the large fuses in the under-hood fuse box by looking through the top at the wire inside. Remove the screws with a Phillips-head screwdriver.
4. Check the smaller fuses in the primary under-hood fuse box and all the fuses in the interior fuse box by pulling out each one with the fuse puller provided in the interior fuse box.
5. Look for a blown wire inside the fuse. If it is blown, replace it with one of the spare fuses of the same rating or lower.
   If you cannot drive the car without fixing the problem, and you do not have a spare fuse, take a fuse of the same rating or a lower rating from one of the other circuits. Make sure you can do without that circuit temporarily (such as the accessory socket or radio).
   If you replace the blown fuse with a spare fuse that has a lower rating, it might blow out again. This does not indicate anything wrong. Replace the fuse with one of the correct rating as soon as you can.
6. If the replacement fuse of the same rating blows in a short time, there is probably a serious electrical problem in your car. Leave the blown fuse in that circuit and have your car checked by a qualified technician.

Passenger Compartment

1. Fuse Box

1. Security Control Unit
2. Electronic Power Steering(EPS) Control Unit
3. Tire Pressure Monitoring System (TPMS) Control Unit
4. Daytime Running Lights Control Unit
5. Audio Unit
6. Throttle Actuator Control Module
7. Low Beam Cut Relay
8. Daytime Running Lights Relay
9. Imoes Unit
10. Keyless Receiver Uni

Instrument Panel Fuse Box Diagram

The interior fuse box is behind the tabs as shown. driver’s coin tray. To access it, remove the tray by turning the dial counterclockwise then pulling it toward you. To install the coin tray, line up the tabs on the bottom, pivot the tray up to engage its side clips, then turn the dial clockwise.

Engine Compartment

1. Fuse Box

Engine Compartment Fuse Box Diagram

The primary under-hood fuse box is in the engine compartment on the driver’s side. To open it, push the tabs as shown. The secondary fuse box is on the positive terminal of the battery.