Mitsubishi L200 (2005-2015) Fuse Diagram

Advertisements

Fuse box diagram (fuse layout), location, and assignment of fuses Mitsubishi L200 (2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015).

Mitsubishi L200 (2005-2015)

Checking and Replacing Fuses

To prevent damage to the electrical system from short-circuiting or overloading, each individual circuit is equipped with a fuse.

Use the fuse location diagrams and the matching tables, to check the fuse that is related to the problem. Look through the clear side of the fuse to see if the metal wire inside is separated. If it is, the fuse is blown and should be replaced. Use a fuse puller (placed on the instrument panel fuse box cover) to remove the fuses. Clamp it on the fuse you wish to remove, and pull the fuse straight out from the fuse block. Insert a new fuse of the same capacity securely into the appropriate slot.

If the fuse is not blown, something else must be causing the problem. Have the system inspected by your authorized Mitsubishi Motors dealer or a repair facility of your choice

Notice

  • Before replacing a fuse, always turn off the electrical item concerned to the fuse and turn the ignition switch to the “LOCK” position or put the operation mode in OFF.
  • Do not repair fuses and never use a fuse with a capacity greater than the one listed or any substitute, such as wire, foil, etc. This would cause the circuit wiring to heat up and could cause a fire.
  • If the replacement fuse blows again after a short time, have the electrical system checked by an authorized Mitsubishi Motors dealer or a repair facility of your choice to find and correct the cause.

The fuse capacity and the name of the electrical systems protected by the fuses are indicated on the inside of the fuse lid located at the driver’s leg area and on the inside of the fuse block cover for fuses located in the engine compartment.


Instrument Panel Fuse Box

The fuse block in the passenger compartment is located behind the cover in front of the driver’s seat at the position shown in the illustration. Pull the fuse lid (A) to remove it.

Instrument Panel Fuse Box Location

Instrument Panel Fuse Box Diagram

Advertisements

 

FunctionA
1Tail lamp (left)7.5
2Cigarette lighter15
3Ignition coil10
4Starter motor7.5
5Sunroof20
6Accessory socket15
7Tail lamp (right)7.5
8Outside rear-view mirrors7.5
9Engine control unit7.5
10Control unit7.5
11Rear fog lamp10
12Central door lock15
13Room lamp10
14Rear window wiper15
15Gauge7.5
16Relay7.5
17Heated seat20
18Option10
19Heated door mirror7.5
20Windscreen wiper20
21Reversing lamps7.5
22Demister30
23Heater30
24Power seat40
25Radio10
26Electronic controlled unit15
27Spare fuse7.5
28Spare fuse20
29Spare fuse30

The fuse block does not contain spare 10 A and 15 A fuses. If a fuse of one of these capacities blows, replace it temporarily by borrowing the one that matches from:

  • 10 A: Radio
  • 15 A: Cigarette lighter

Replace the borrowed fuse as soon as possible

Advertisements


Engine Compartment Fuse Box

In the engine compartment, the fuse block is located as shown in the illustration.

Engine Compartment Fuse Box Location

  1. Push the knob.
  2. Remove the cover.

Engine Compartment Fuse Box Diagram

FunctionA
1
2Electric window system40
3Ignition switch40
4Air conditioning compressor10
5Condenser fan motor20
6Headlamp high-beam (left)10
7Headlamp high-beam (right)10
8Headlamp low beam (left)10
9Headlamp low beam (right)10
10Engine control20
11Alternator7.5
12Stop lamps15
13Horn10
14Automatic transmission20
15Hazard warning flasher10
16Fuel pump15
17Front fog lamps15
18Audio amp20

 

Advertisements