Mitsubishi Eclipse (4G; 2006-2012) Fuse Diagram • FuseCheck.com

Checking and Replacing Fuses

To prevent damage to the electrical system from short-circuiting or overloading, each individual circuit is equipped with a fuse.

Use the fuse location diagrams and the matching tables, to check the fuse that is related to the problem. Look through the clear side of the fuse to see if the metal wire inside is separated. If it is, the fuse is blown and should be replaced. Use a fuse puller (it is in the instrument panel fuse box cover) to remove the fuses. Clamp it on the fuse you wish to remove, and pull the fuse straight out from the fuse block. Insert a new fuse of the same capacity securely into the appropriate slot.

If the fuse is not blown, something else must be causing the problem. Have the system inspected by your authorized Mitsubishi Motors dealer or a repair facility of your choice

Notice

Before replacing a fuse, always turn off the electrical item concerned to the fuse and turn the ignition switch to the “LOCK” position or put the operation mode in OFF.
Do not repair fuses and never use a fuse with a capacity greater than the one listed or any substitute, such as wire, foil, etc. This would cause the circuit wiring to heat up and could cause a fire.
If the replacement fuse blows again after a short time, have the electrical system checked by an authorized Mitsubishi Motors dealer or a repair facility of your choice to find and correct the cause.

This fuse lists show the names of the electrical systems and their fuse capacities. There are spare fuses in the cover of the instrument panel (driver’s side).

Instrument Panel Fuse Box

The fuse block in the passenger compartment is located in front of the driver’s seat at the position shown in the illustration.

№	Function/component	A
1	Ignition coil	10
2	Gauge	7.5
3	Back-up lights	7.5
4	Electric convertible top	7.5
5	Relay	7.5
6	Door mirror heater	7.5
7	Not used	—
8	Engine control	7.5
9	Not used	—
10	Not used	—
11	Outside rearview mirrors	7.5
12	Engine control	7.5
13	Not used	—
14	Rear window wiper	15
15	Power door locks	15
16	Power outlet	15
17	Not used	—
18	Not used	—
19	Heater	30
20	Rear window defogger	30
21	Sunroof	20
22	Not used	—
23	Electric window control	7.5
24	Electric convertible top	15
25	Spare fuse	20
26	Spare fuse	30
27	Spare fuse	30

The fuse block does not contain spare 7.5 A, 10 A and 15 A fuses. If a fuse of one of these capacities blows, replace it temporarily by borrowing the one that matches from:

5 A: Door mirror heater
10 A: Dome light (in the engine compartment)
15 A: Power outlet

Replace the borrowed fuse as soon as possible.

Engine Compartment Fuse Boxes

In the engine compartment, the fuse blocks are located as shown in the illustration.

A – Type A
B – Type B (ECLIPSE SPYDER only)
C – Type C (2.4-liter models only)

Type A:

Push the lock lever.
Remove the fuse block cover.

Type B (ECLIPSE SPYDER only):

Pull the lock lever.
Open the cover.

Type C (2.4-liter models only):

Push the lock lever.
Remove the relay box cover.

Diagrams

Type A & B

Type C

№	Type A	A
1	Fuse (+B)	80
2	Radiator fan motor	30 (2) 50 (3)
3	Anti-lock braking system	60
4	Ignition switch	40
5	Power window control	30
6	Front fog lights	15
7	Heated seat	20
8	Horn	15
9	Engine control	20
10	Air conditioning	10
11	Stop lights	7.5
12	Audio	30
13	Alternator	7.5
14	Hazard warning flasher	10
15	Automatic transaxle	20
16	Headlight high beam (right)	10
17	Headlight high beam (left)	10
18	Headlight low beam (right)	10 (4) 20 (5)
19	Headlight low beam (left)	10 (4) 20 (5)
20	Position light (right)	7.5
21	Position light (left)	7.5
22	Dome light	10
23	Radio	15
24	Fuel pump	15
25	Windshield wiper	30
Type B
26	Electric convertible top	40
Type C
1	Condenser fan motor	20
2) Fusible link (2.4 liter models); 3) Fusible link (3.8 liter models); 4) Except for vehicles with high intensity discharge headlights; 5) Vehicles with high intensity discharge headlights.