Suzuki Ciaz (2014-2018) Fuse Diagram

Advertisements

Fuse box diagram (fuse layout), location, and assignment of fuses Suzuki Ciaz (2014, 2015, 2016, 2017, 2018).

Suzuki Ciaz (2014-2018)

Checking and Replacing Fuses

The fuses are designed to melt during an overload to prevent damage to the wiring harness and electrical equipment. If any lights, accessories or other electrical controls do not operate, inspect the corresponding fuse. Look through the clear side of the fuse to see if the metal wire inside is separated. If it is, the fuse is blown and should be replaced.

Notice

  • Before replacing the fuses, turn the ignition switch to the “LOCK” position and turn off all electrical accessories.
  • Always be sure to replace a blown fuse with a fuse of the correct amperage. Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire.
  • Never use a substitute such as a wire even for a temporary repair, or extensive electrical damage, and a fire can result.
  • We recommend always carrying replacement fuses in the vehicle.
  • If the main fuse or a primary fuse blows, be sure to have your vehicle inspected by an authorised Suzuki workshop.
  • If you replace a fuse and the new one blows in a short period of time, you may have a major electrical problem. Have your vehicle inspected immediately by your authorised Suzuki workshop.

Your vehicle has three types of fuses, as described below:

  • Main fuse: The main fuse takes current directly from the battery.
  • Primary fuses: These fuses are between the main fuse and individual fuses, and are for electrical load groups.
  • Individual fuses: These fuses are for individual electrical circuits.

 


Instrument Panel Fuse Box Diagram

The fuse box is located under the driver’s side of the dashboard. Remove the fuse box cover by pushing in at both ends and pulling off the cover.

Instrument Panel Fuse Box Location

Instrument Panel Fuse Box Diagram

AFunction/component
120Power window
220Steering lock
3-Not used
420Rear defogger
5-Not used
6-Not used
7-Not used
87.5Starting Signal
915ACC-2
1030Power window
1110Hazard
127.5BCM
1315Ignition coil
1410ABS control module
1515ACC
1610A-STOP controller
1715Horn
1810Stop light
1910Air bag
2010Back-up light
2115WIP
2225Front wiper
237.5Dome light
24-Not used
25-Not used
26-Not used
277.5Ignition-1 signal
2815Radio 2
2910ACC-3
3015Radio
3110Tail lamp
3220D/L
337.5Stop lamp sw / Clutch sw
3410Meter
357.5Ignition-2 signal
36-Not used

Advertisements


Engine Compartment Fuse Box Diagram

The main fuse, primary fuses, and some of the individual fuses are located in the engine compartment. If the main fuse blows, no electrical component will function. If a primary fuse blows, no electrical component in the corresponding load group will function.

Engine Compartment Fuse Box Diagram (on the battery)

Engine Compartment Fuse Box Diagram

To remove a fuse, use the fuse puller provided in the fuse box. The amperage of each fuse is shown in the back of the fuse box cover.

AFunction/component
1100FL1 (GAS)
450FL1 (DIESEL)
2100FL2
3100FL3
450FL4
580FL5
6100FL6
750Ignition switch -2
87.5ECM
015Automatic transaxle relay
10-Not used
1110Air compressor
1215FI (GAS)
1330FI (DIESEL)
1460Power steering
1530Radiator tan
1630CDSR
1730Blower fen
1830Starting motor
1940ABS motor
2030B/U
2115Headlight Lo (Left)
2215Headlight Lo (Right)
2325ABS control module
2430DCDC
2520Front fog light
2625Headlight
2740Ignition switch
287.5Starting Signal
2920INJ DRV (DIESEL)
3010FI 2
3115F/P (DIESEL)
3215Headlight high (Left)
3315Headlight high (Right)
34-Not used
357.5WIP SUB

 

Advertisements