Advertisements
Fuse box diagram (fuse layout), location, and assignment of fuses Subaru Impreza (1998, 1999, 2000, 2001).
Checking and Replacing Fuses
The fuses are designed to melt during an overload to prevent damage to the wiring harness and electrical equipment. If any lights, accessories or other electrical controls do not operate, inspect the corresponding fuse. If a fuse has blown, replace it.
- Turn the ignition switch to the “LOCK” position and turn off all electrical accessories.
- Remove the cover.
- Determine which fuse may be blown.
- Pull out the fuse with the fuse puller. The fuse puller is stored in the main fuse box cover in the engine compartment.
- Inspect the fuse. If it has blown, replace it with a spare fuse of the same rating. The spare fuses are stored in the main fuse box cover in the engine compartment.
- If the same fuse blows again, this indicates that its system has a problem. Contact your SUBARU dealer for repairs.
Notice
- Never replace a fuse with one having a higher rating or with material other than a fuse because serious damage or a fire could result.
- We recommend always carrying replacement fuses in the vehicle.
Instrument Panel Fuse Box
The fuse box is located behind the coin tray on the driver’s side. Open the coin tray and pull it horizontally to remove it.
| № | A | Circuits Protected |
|---|---|---|
| 1 | 15 | Heater fan |
| 2 | 15 | Heater fan |
| 3 | 15 | Spare |
| 4 | 20 | Front accessory power socket, Cigarette lighter, Remote controlled rear view mirrors |
| 5 | 10 | Tail light, Parking light |
| 6 | 15 | SRS airbag |
| 7 | 15 | Fog light |
| 8 | 20 | ABS solenoid |
| 9 | 15 | Radio, Clock |
| 10 | 15 | Spare |
| 11 | 15 | Engine ignition system, SRS airbag |
| 12 | 10 | Illumination brightness control |
| 13 | 15 | Spare |
| 14 | 15 | AT shift lock unit, ABS control, Cruise control |
| 15 | 20 | Windshield wiper and washer, Rear window wiper and washer |
| 16 | 20 | Brake light |
| 17 | 15 | Air conditioner |
| 18 | 15 | Backup light, Turn light, SRS airbag system warning light |
| 19 | 20 | Rear accessory power socket, Seat heater |
Advertisements
Engine Compartment Fuse Box
| № | A | Circuits Protected |
|---|---|---|
| 20 | 20 | Radiator cooling fan (Main) |
| 21 | 20 | Radiator cooling fan (Sub) |
| 22 | 20 | Rear window defogger |
| 23 | 15 | Hazard warning flasher, Horn |
| 24 | 15 | Power door lock |
| 25 | 10 | Automatic transmission control unit |
| 26 | 10 | Alternator |
| 27 | 15 | Headlight (right side) |
| 28 | 15 | Headlight (left side) |
| 29 | 20 | Lighting switch |
| 30 | 15 | Clock, Interior light |
Main fuse and fusible link
The main fuses and fusible links are designed to melt during an overload to prevent damage to the wiring harness and electrical equipment. Check the main fuses and fusible link if any electrical component fails to operate (except the starter motor) and other fuses are good. A melted main fuse or fusible link must be replaced. Use only replacements with the same specified rating as the melted main fuse or fusible link. If the main fuse or fusible link blows after it is replaced, have the electrical system checked by your nearest SUBARU dealer.
Advertisements